2015WC/2015WCOL Wine Captain® | ™ |
|
|
5 Adjust Door
Checking Door Alignment
The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during overlay frame installation.
IMPORTANT
Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 23).
1/8" |
Figure 23 |
1.Compare the top edge of the door to the top edge of the cabinet.
2.If the door edge is 1/8" below and parallel to the top of the cabinet, go on to 6 Prepare Power Supply. If it is not, note whether the side opposite the hinge needs to be moved UP or DOWN, and use the following procedure.
Slotted |
|
Mounting |
|
Holes | Angled Edge |
| |
| Towards Center |
| of Door |
Raise | Lower |
Outside | Outside |
Door Edge | Door Edge |
Figure 25 |
|
3.See Figure 25. If the top far edge of the door needs to move UP, move the hinge plate toward the outside of the door and retighten screws. If the top far edge of the door needs to move DOWN, move the hinge plate toward the inside of the door and retighten screws.
4.Mount the door to recheck alignment and repeat Steps 2 and 3 if further adjustment is necessary.
5.When top edge of door is parallel to top edge of cabinet, remove the door and ensure the two screws are secure.
6.Remove the door closers from the bottom hinge, clean thoroughly and lubricate the mating surfaces with petroleum jelly.
Adjusting Door Alignment
1.Remove top hinge screw pin (7/64" Allen wrench or
Phillips screwdriver, depending on your unit’s construction, see Figure 24). Remove door by tilting forward and lifting off bottom hinge pin.
2. With door | Figure 24 |
| |
loosen but do not remove |
|
the two screws on the door’s bottom hinge plate. | |
7.Reinstall the closers, lining up the bosses with holes in hinge and hinge plate (see Figure 26).
8.Mount the door, install top hinge pivot pin and go on to 6 Prepare Power Supply.
Door |
Closer |
Inserts |
Boss |
Figure 26 |
12 | 02/2005 |
