Door
Figure 16

2015WC/2015WCOL Wine Captain®

 

 

Installation Instructions

Preparing Door

Gasket

Note: Door is not attached. It is in a separate box inside the unit box and taped to the unit.

1. Lay door on a clean, flat surface with the gasket facing up.

2. Pull gasket completely out of the groove. Start in the middle and pull outward, moving toward the edge

(see Figure 16). This may take some force.

Note: Lay gasket flat on a clean surface to avoid disturbing interior magnet.

Checking Overlay Fit

Not Fully Seated

Little or No Gap

Objectional Gap

Figure 17

1.Turn door over and lay overlay frame on front side of door. Make sure frame is fully seated on all four sides. See Figure 17.

2.Visually check for gap between frame and glass. If there is an objectionable gap, follow steps under Applying Foam Tape to Overlay Frame. If there is little or no gap, continue to Attaching the Overlay Frame.

Applying Foam Tape to Overlay Frame (If required)

 

Inside Edge

Incorrect

Correct

Figure 18

 

1.Cut foam tape into four pieces, two pieces the width of the overlay frame and two pieces the height of the overlay frame.

2.Remove the adhesive protection strip from one piece of the foam tape and align to the edge of the overlay frame as shown in Figure 18, adhering the foam tape to the overlay frame.

3.Trim each piece of tape immediately after application. Do not allow any overlapping of the foam tape. Damage to the overlay frame can occur if the foam tape is not trimmed properly.

Typical Wood

Frame

#6 X 5/8"

Flat Head Screw

Two Required

Top Pivot

Plate

8 mm Plug Insert

Two Required

Figure 19

Attaching the Overlay Frame

1.Tap nylon inserts into the top holes drilled in the overlay frame. Use two #6 screws to attach top pivot bracket to the overlay frame (see Figure 19).

2.If a user-supplied cabinet handle will be used, attach its hardware to the overlay frame at this time.

IMPORTANT

User-supplied cabinet handle MUST be counter bored to make sure mounting hardware is below surface of overlay frame. Failure to do so can cause damage to overlay frame and/or door. Overlay frame will not sit flush to door if mounting hardware is not counter bored.

www.U-LineService.com

10

02/2005

Page 10
Image 10
U-Line 2015WCOL manual Installation Instructions, Preparing Door