U-Line 2015WCOL manual Anti-Tip Bracket Installation, Install the Unit

2015WC/2015WCOL Wine Captain® ™

8 Install the Unit

Anti-Tip Bracket Installation

1.Locate two Anti-Tip Brackets included inside the unit.

2.Place the unit into the area where it will be installed. Check the door, sides and top for a proper fit. Also test to make sure the door opens and closes freely.

3.Remove grill and place a mark on the floor at the front of the unit. Also place a mark on the floor in the center of the unit. See Figure 30.

	Back	Line Marks
Front	Wall	Back
		of Unit
of Unit
		20-1/4"
Marks	6-9/16"	6-9/16"
on Floor
	Centerline
Figure 31

5.Place the Anti-Tip Brackets on the floor against the line drawn for the outer edge. Mark spots for the screw holes. See Figure 32.

Marks on Floor

Figure 30

4.Remove the unit. Using a square, extend a centerline 20-1/4" toward the back wall. See Figure 31. At the back of the centerline, mark a line that measures

6-9/16" to the left and right. This line serves as the back edge for the Anti-Tip Brackets and its furthest points mark the outer edge of each bracket.

Note: Instructions are shown for built-in installation. Use same dimensions for free-standing installation.

Drill Holes and

Mount Anti-Tip

Brackets to Floor

Back

of Unit

Front

of Unit

Figure 32

Back Wall

6.Use a 1/8" drill to make two starter holes and fasten the Anti-Tip Brackets to the floor using the screws provided.

CAUTION

Other hardware is required for floors made of materials other than wood.

7.Place the unit back into position, making sure the feet engage the Anti-Tip Brackets properly. Check the alignment of the lines made on the floor in Step 3 with the position of the front feet to ensure proper positioning.

www.U-LineService.com 14 02/2005