™ | 2015WC/2015WCOL Wine Captain® |
|
|
Tape | Door |
| Frame |
| Overlay |
| Frame |
Figure 20 |
|
3.Secure the front of the door to the back of the overlay frame using tape on all four corners, as shown in Figure 20. Make sure all four edges are aligned.
Note: The door frame is designed with a slight amount of “play” to square it to the overlay frame.
6.Remove all traces of tape securing overlay frame to door frame.
7.Starting at the corners and working toward the center, push the door gasket back into place. Make sure gasket is seated on all four sides.
Installing the Door
IMPORTANT
Pivot posts must be clean. Closers must also be clean and greased to ensure proper operation.
1.Insert pivot post into bottom hinge, making sure to tighten only until post is level with outside of hinge.
2.Install door closer. See Figure 26 on Page 12. Be sure that bosses on closers align with holes in hinge.
Pivot Post
Rear View
of
Door and
Overlay Frame
Punch Pilot Holes for use with #6 x 1"
Top Pivot Plate
Figure 21
4.Place door and overlay frame on a flat, clean protective surface. Use the door frame holes as a guide to lightly punch pilot holes for the #6 x 1"
5.Attach the door to the overlay frame using the #6 x 1" wood screws.
IMPORTANT
If you decide to drill pilot holes, remove the door and do not use a drill bit larger than 7/64". Do not drill deeper than 3/8". Door frame and overlay frame must be aligned properly or the door will not operate correctly.
Figure 22
3.Holding door upright with top of door tilted forward, place hole of pivot plate onto bottom hinge screw pin. Be sure that bosses on closers align with holes in pivot plate.
4.Tilt top of door into position and install top hinge screw pin. See Figure 22. Tighten only until post is level with top of hinge.
5.Go on to 5 Adjust Door.
02/2005 | 11 |
