5.On a clean surface, place the wood panel face down and tape the existing drawer panel (removed in step 3) on the back of the wood panel (Figure 10) and drill the five (5) holes (5/32" drill 3/8" deep) through the coated steel panel and 3/8" into the wood panel according to the diagram (Figure 11). Remove tape from the draw- er panel, and enlarge the five holes in the front panel using a .0201" drill (#7) drill.
| SIDE OF |
|
BACK OF | WOOD PANEL | COATED STEEL |
WOOD PANEL |
| |
| DRAWER PANEL | |
| TAPE | |
|
|
NOTE:
For 1/2" gap between top and bottom panels, this dimension must be 11/32". For 1/4" gap, this dimension must be 19/32" for TOP PANEL ONLY.
BOTTOM OF WOOD PANEL
3/8" BOTH SIDES
DWR_OL_003
Figure 10
TOP OF WOOD PANEL | COATED STEEL |
| |
| DRAWER PANEL |
|
B
A
5/32" X 3/8" DEEP 5 PLACES
C
1" | 1" |
DWR_OL_004
Figure 11
13