User’s Manual

TEMPERATURE CONTROLLER

1 2

WARMER

COOLER

SET

TEMP

CLRCO011B

Figure 17

The temperature controller (Figure 17) is located in the top drawer. It consists of an LED display, two LED status indicator lights and three touch pad buttons. The LED display shows the temperature set point and is calibrated in degrees Fahrenheit. The controller is factory programmed for a set point of 38°F which will show when the unit is first powered-up.

To display actual temperature, press the “WARMER” button momentari- ly. A solid status indicator light (1, Figure 17) will show the air temperature reading in the cabinet for approximately 10 seconds.

To adjust the temperature set point, press the “SET TEMP” button momentarily; the display will flash. Press the “WARMER” or “COOLER” button as desired to change the set point. When the desired set point shows on the display, wait 10 seconds and the new set point will be saved. Wait 24 hours for the temperature to stabilize before checking the actual temperature again.

Refer to Table 1 to determine indicator light status.

LED

Status

Indicates

 

 

 

1

• Solid

• Refrigerator Temperature displayed

 

• Flashing

• Not Applicable

 

 

 

2

• Flashing

• Open Thermistor – call for service

 

 

 

Table 1. Indicator Light Status

18