5.Slide custom drawer panel insert into 1/4" channel in drawer front.

6.Attach the full handle to the lower handle using the 3 screws removed in step 2.

7.Holding drawer gasket out of the way, replace handle on drawer making sure it is seated properly on insert and that screw holes line up.

8.Install two screws removed in step 3.

9.Starting at the corners and working inward, push drawer gasket into place on the drawer.

INITIAL START-UP AND ADJUSTING

THE TEMPERATURE CONTROL

Once the installation is complete, the unit is ready for initial start-up and operation.

1.Plug the appliance cord into a 115V polarized, grounded electrical outlet.

The unit is turned ON with the ON/OFF switch in the front grille (Figure 16). (All units are shipped in the ON position.)

2.Wipe out inside of unit with a clean, water-dampened cloth.

 

OFF

 

ON

ON/OFF SWITCH

DWR011

Figure 16

17