User’s Manual
Install the custom insert as follows:
!WARNING
Insert edges may be SHARP! Use care when installing.
1.Open drawer. Pull drawer gas- ket out of groove (top edge of drawer only). Start in the mid- dle and pull outward, moving toward the edge (Figure 14). This may take some force, be careful.
2.Remove the three screws behind the gasket. Carefully pull the top handle up and off. You may discard the top handle as it will be replaced with the full handle.
3.Remove the two outside screws and the lower handle (Figure 15).
4.Remove existing panel and cardboard spacer. The panel and spacer are no longer need- ed and may be discarded.
FULL HANDLE SHOWN
DWR020
Figure 14
STANDARD
HANDLE
FULL HANDLE
Figure 15
16