Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
H (phones) terminal
Speaker
SET dial
When Using Headphones
The headphones terminal also serves as AV terminal. Headphones can only be used when “H” is displayed on the screen. If not, change the setting following the procedure below.
CAMERA | PLAY (VCR) |
|
| CARD CAMERA | CARD PLAY | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| VCR SETUP |
|
|
| AV/PHONES | ••AV | |
( | 37) |
Open the menu and select [VCR SETUP]. Select [AV/PHONES H], set it to [PHONES H] and close the menu.
❍The speaker does not sound when “H” is displayed.
❍Do not connect headphones unless “H” is displayed as it produces noise.
Adjusting the Volume
CAMERA | PLAY (VCR) | CARD CAMERA | CARD PLAY |
|
|
|
|
Turn the SET dial up to increase the volume, and down to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the volume again.
E 
Playback | Basic Functions |
| - |
33
