U-Line CLR1215 quick start Sabbath Mode

QUICK START GUIDE

u-line.com

The ice cube thickness is factory set for best overall performance. The factory setting “0” is designed to maintain an ice bridge of approximately 1/16" to 1/8"

(1.6 mm to 3.2 mm) under normal conditions, resulting in a dimple of approximately 1/4" to 1/2" (6.4 mm to

12.7mm) in depth. A fuller cube with less of a dimple results in a thicker ice bridge. As the ice bridge becomes thicker, the tendency for the cubes to stay together as a slab increases. A bridge thicker than 1/8" (3.2 mm) may cause cubes to overfill the ice bucket.

DIMPLES

ICE BRIDGE

Ice Bridge and Dimples

	Cube Types
1/4" TO 1/2"		1/16" TO 1/8"
(6.4 mm to 12.7 mm)		(1.6 mm to 3.2 mm)
DIMPLE		ICE BRIDGE

	THIN BRIDGE	THICK BRIDGE
DEEP DIMPLE		LITTLE OR
		NO DIMPLE

Adjust ice thickness as follows:

1.Press and hold for 5 seconds (display will show current settings).

2.Press to make cube thicker or to make cube thinner.

The total range of adjustment is -5 (thinest) to +5 (thickest). If further adjustments are desired, repeat steps 1 and 2.

L

Sabbath Mode

Power

U-Line Clear Ice Machine models are Star-K certified and can be used during the Sabbath. View a full list of Star-K certified U-Line units at www.star-k.org.

To prepare the unit for the Sabbath:

1.Press and hold until the unit turns off.

2.No new ice will form when the unit is off, but previously made ice will still be accessible/present for over 24 hours. Pump equipped models will continue to remove water as needed even if the unit is off.

Sabbath Mode remains active until is pressed again and the unit turns on.

10