U-Line CLR1215 Quick Start Guide, General Installation, Leveling Information, Installation Tip

QUICK START GUIDE

u-line.com

General Installation	INSTALLATION
LEVELING INFORMATION	1. Open the water supply valve in the main water source.

1. Use a level to confirm the unit is level. Level should be placed along top edge and side edge as shown.

1

2.If the unit is not level, adjust the feet on the corners of the unit as necessary.

Turn Foot to Adjust

3.Confirm the unit is level after each adjustment and repeat the previous steps until the unit is level.

INSTALLATION TIP

If the room floor is higher than the floor in the cut-out opening, adjust the rear feet to achieve a total unit rear height of 1/8" (3 mm) less than the opening’s rear height. Shorten the unit height in the front by adjusting the front feet. This allows the unit to be gently tipped into the opening. Readjust the front feet to level the unit after it is correctly positioned in the opening.

2.Plug in the power cord.

3.Gently push the unit into position. Be careful not to kink the water supply line, the drain line, or entangle the power cord.

4.Re-check the leveling, from front to back and side to side. Make any necessary adjustments. The unit’s top surface should be approximately 1/8" (3 mm) below the countertop.

8