U-Line CLR1215 quick start Water Hookup, Quick Start Guide

Models: CLR1215

1 15
Download 15 pages 10.76 Kb
Page 6
Image 6
Water Hookup

QUICK START GUIDE

u-line.com

Water Hookup

INDOOR MODELS

PREPARE PLUMBING

Please use the braided stainless steel water supply line which comes attached. The water line is fitted with a standard 1/4" (6.35 mm) compression fitting.

Do not use Teflon tape or joint compound on the water fitting. The rubber washer provides an adequate seal. Other materials could cause blockage of the valve.

Failure to follow recommendations and instructions may result in damage and/or harm, flooding or void the product warranty.

!WARNING

Prior to installation, determine if this product contains a gravity style drain or factory installed drain pump. Products without a drain pump may only use a gravity style drain. Failure to connect water supply or drain line connections properly may result in water leakage, personal injury, and/or property damage. Disconnect power and turn off water to the unit before attempting to alter these connections. These connections are the responsibility of the owner and must be connected per local plumbing code. If you are uncertain of how to safely and properly install this product, contact a licensed plumber.

Water Supply Connection

!CAUTION

Review, obey, and understand the local plumbing codes before you install your unit. Connect to the cold water supply. The water pressure should be between 20 and 120 psi. The water line MUST have a shut-off valve on the supply line.

!CAUTION

Turn off water supply and disconnect electrical supply to unit prior to installation.

1.Turn off water supply and disconnect electrical supply to product prior to attempting installation.

2.Locate the desired cold water supply location.

3. Locate braided stainless steel water supply line and connect to your cold water supply. The water line should

be looped into 2 coils. This

will allow the unit to be removed for cleaning and servicing. However, make

certain that the tubing is not pinched or damaged during installation.

4. Turn on water and check for leaks.

!CAUTION

Do not use any plastic water supply line. The line is under pressure at all times. Plastic may crack or rupture with age and cause damage to your home.

3

Page 6
Image 6
U-Line CLR1215 quick start Water Hookup, Quick Start Guide