U-Line CLR1215 quick start Drain, Quick Start Guide

QUICK START GUIDE

u-line.com

3. Locate water valve in the front of the unit and thread water supply line through.

NOTICE

Route the water supply line through the unit

so it does not come into contact with any internal components other than the solenoid valve. Normal operation creates some vibration. A water supply line contacting an internal component or cabinet wall can cause excessive noise during operation or damage to the line.

4. On the back panel, break away filler feature in bushing, with flat screwdriver.

Remove

ZLWKɠDW

screwdriver

5. Thread water line through back panel hole (with bushing).

6.Turn on water supply and check for leaks.

7.Reinstall back panel and grille/front access panel.

8. Install retaining clip.

Drain

Models ending in (-00A, -01A) will not be equipped with factory installed drain pump.

Models ending in (-40A, -41A) will have the factory installed drain pump.

DRAIN CONNECTION

!CAUTION

If your U-Line unit did not come with a factory installed drain pump you must use a gravity style drain connection. For assistance in determining if your unit has a pump please contact U-Line. The floor drain must be large enough to accommodate drainage from all attached drains. Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/ or potentially flowing onto the floor, which may result in personal injury or property damage.

5