QUICK START GUIDE
5. Route water supply line in cable clamp and secure with | Water Supply Connection |
screw. | ! CAUTION |
| |
| Review, obey, and understand the local |
| plumbing codes before you install your unit. |
| Connect to the cold water supply. The water |
| pressure should be between 20 and 120 psi. The |
| water line MUST have a |
| supply line. |
OUTDOOR MODELS
PREPARE PLUMBING
The water valve in this unit uses a standard 1/4" (6.35 mm) compression fitting.
!WARNING
Prior to installation, determine if this product contains a gravity style drain or factory installed drain pump. Products without a drain pump may only use a gravity style drain. Failure to connect water supply or drain line connections properly may result in water leakage, personal injury, and/or property damage. Disconnect power and turn off water to the unit before attempting to alter these connections. These connections are the responsibility of the owner and must be connected per local plumbing code. If you are uncertain of how to safely and properly install this product, contact a licensed plumber.
!CAUTION
Do not use any plastic water supply line. The line is under pressure at all times. Plastic may crack or rupture with age and cause damage to your home.
Do not use Teflon tape or joint compound on the water fitting. The rubber washer provides an adequate seal. Other materials could cause blockage of the valve.
Failure to follow recommendations and instructions may result in damage and/or harm, flooding or void the product warranty.
!CAUTION
Turn off water supply and disconnect electrical supply to unit prior to installation.
Use caution when handling back panel. The edges could be sharp.
1.Turn off water supply and disconnect electrical supply to product prior to attempting installation.
2.Remove the grille/access panel in the front and the back panel.
4
