U-Line CLR1215 quick start Control Operation, First Use, Quick Start Guide, Up Down, Alert

QUICK START GUIDE

u-line.com

Control Operation

Up Down		Alert
	Light Power Clean LED

CONTROL FUNCTION GUIDE

FUNCTION	COMMAND			DISPLAY/OPTIONS
ON/OFF	Press	and release		Unit will immediately turn ON or OFF.
Adjust ice thickness	See “Ice” section
View temperature in unit	Press	and	together and release	The display will flash and then toggle from set point
				to temperature in unit.
Toggle between F/C	Hold	and	for five seconds	The display will beep and display unit temperature.
Sabbath Mode	See “Sabbath Mode” section
Silent Mode (ice
production suspended for	Hold	and		Display will show “OFF”.
3 hours)
Clean Mode	Hold	for five seconds

First Use

All U-Line controls are preset at the factory. Initial startup requires no adjustments.

NOTICE

U-Line recommends discarding the ice produced during the first two to three hours of operation to avoid possible dirt or scale that may dislodge from the water line.

When plugged in, the unit will begin operating under the factory default settings. If the unit was turned off during installation, simply press and the unit will immediately switch on. To turn the unit off, press and hold for 5 seconds and release.

Ice

ICE CUBE THICKNESS ADJUSTMENT

NOTICE

Ice thickness adjustment should only be made one increment at a time. Allow ice maker production to stabilize for 24 hours before rechecking ice thickness.

Ice cubes in any given batch will vary, so it is necessary to choose cubes from the sample area for comparison when making adjustments.

9