Uniden 2165 Registration, Place the handset in the Main Base Unit Fig, Handset, Number, On a Call

If a Handset is registered at any time as Handset 1, all other Handsets will need to be registered again from Step 1.

If you have additional Handsets, repeat the same process, but at Step 2 select a number from 3 - 7 to register the next handset.

The Registration process needs to be completed within 15 seconds, 5 beep tones will indicate that the time has been exceeded. Please start the process again.

After Registration the Handset number is shown on the Display screen either during a call or while the Handset is charging (Fig 4).

REGISTRATION

The Handset/s supplied with your DSS2155/DSS2165 have already been registered. For additional Handsets it is very important to allocate each Handset a different number to enable functions such as Call Transfer.

Registration Process

Follow this process for each additional Handset (DSS2105) that needs to be registered to the Main Base or for registering your Main Handset.

1.Remove the Handset from its charger

2.Press flash/reg on the Handset (Fig 1).

3.For Handset DSS2155 - Press the number 2 (Fig.2) to register as Handset 2 (Handset numbers 2-7 are available).

For Handset DSS2165 - Press the number 3 to register Handset 3 (Handset numbers 3-7 are available).

Fig 1.	REGISTER AS
	HAND #2

Fig 2.

4. Place the handset in the Main Base Unit (Fig 3).

5. Press and hold the Registration button located on the back of the Main Base unit near the DC power jack (Fig 3). Hold the Registration button in until a long beep confirms the handset has been registered.

Fig 3.

			TALK HIGH 1	Handset
Fig 4.	HANDSET	1
	NEW:	0		Registration
				number
	TOTAL:	0
				displayed
	Charging		On a Call

15