To record an OGM 2 message Hold down OGM 2 until | Uniden 7000A

PREPARATION

NOTE:				Do not tell the callers that you are not home. Instead, say that
				you cannot come to the phone right now.

2.Speak in a normal voice about 20cm (8 inches) away from the microphone (located on the front of the DTAM). If you record the OGM 1 message, ask for the caller’s name, phone number and message.

3.When you finish recording,

press . The DTAM automatically plays back the outgoing message.

To record an OGM 2 message,

hold down OGM 2 until the

DTAM beeps and (Announcement 2) appears. Repeat steps 2 and 3.

NOTE:	• If no outgoing OGM1 is recorded when you press	OGM 1 , the

DTAM announces "You have no announcement one" and sounds four beeps.

•If no outgoing OGM2 is recorded when you press OGM 2 , the DTAM announces "You have no announcement two" and sounds four beeps.

PREPARATION

21

Image 21

Uniden 7000A manual To record an OGM 2 message Hold down OGM 2 until, Dtam beeps and Announcement 2 appears. Repeat steps 2

Contents

7000A Page Contents Contents Read this Before Installation Safety Information Safety Information Safety Information Introduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include Features Features Outgoing Message FunctionsMessage Light Answer Functions Selecting a Location Installation Connecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with this Push down the latch to release the battery compartment cover Page Preparation Setting the DAY and Time Recording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 message Dtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 until Preparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce Only Recording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the Dtam Adjusting the Volume Playing MessagesDown for 2 seconds Pause Message Playback Deleting Messages Fast Playback Recording a Memo Using Call Breakthrough Changing the CBT Code Press Dtam beepsReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-on Then Remote Operation Press Using Remote Commands Remote Operation Problem Suggestion Troubleshooting Your problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolve Unplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead