Remote Operation, Call your telephone | Uniden 7000A specs

REMOTE OPERATION

REMOTE OPERATION

You can operate the DTAM from any remote location using a touch-tone phone, or from a rotary phone using a pocket tone- dialler.

Call your telephone

When you hear the OGM, enter your security code. After a long beep, enter your remote command code(s).

If you do not hear an OGM, the unit is either in Answer-off mode or is not setup properly.

Remote Answer-on

•Call your telephone (After 15 rings you will hear "Answer Off")

•Enter your remote security code within 8 seconds. (The DTAM beeps to confirm valid code)

•Enter 0 1 for OGM1 or 0 2 for OGM2 (Announce only)

•The DTAM announces "Answer On’, Then plays your selected OGM.

REMOTE OPERATION

NOTE: • An outgoing message must be recorded before you can remotely set the DTAM to answer calls.

•If you do not enter each digit of the security code within 8 seconds, the DTAM hangs up. If the DTAM is set to answer-on, it answers according to the number of rings you set. The DTAM plays OGM1.

33

Image 33

Uniden 7000A manual Remote Operation, Call your telephone, Remote Answer-on

Contents

7000A Page Contents Contents Read this Before Installation Safety Information Safety Information Safety Information Introduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include Features Features Outgoing Message FunctionsMessage Light Answer Functions Selecting a Location Installation Connecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with this Push down the latch to release the battery compartment cover Page Preparation Setting the DAY and Time Recording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 message Dtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 until Preparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce Only Recording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the Dtam Adjusting the Volume Playing MessagesDown for 2 seconds Pause Message Playback Deleting Messages Fast Playback Recording a Memo Using Call Breakthrough Changing the CBT Code Press Dtam beepsReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-on Then Remote Operation Press Using Remote Commands Remote Operation Problem Suggestion Troubleshooting Your problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolve Unplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead