Basic Operation, Setting the Dtam to Answer Calls | Uniden 7000A

BASIC OPERATION

SETTING THE DTAM TO ANSWER CALLS

To Turn The DTAM On

To turn on the DTAM and set it to answer calls and record messages, press answer once. The DTAM announces "Answer-on", beeps once and plays the outgoing message. The red “Answer-on” indicator lights up. The DTAM is now set to answer calls using the OGM 1 message and record callers’ messages.

To Announce Only

To set the DTAM to answer calls but not record messages, press OGM 2 when the DTAM is set to “Answer-on" mode. The DTAM announces "Announce only", beeps and plays your announcement,

then displays (Announce only). The DTAM is now set to answer calls using the OGM 2 message without recording callers’ messages. To swap between recording messages (OGM 1) or announce only (OGM 2 ) simply press OGM 1 or OGM 2 as required.

To Turn The DTAM Off

To turn off the DTAM so it does not answer calls, press answer again. The DTAM announces “Answer off”, beeps and the red “Answer-on” indicator turns off.

BASIC OPERATION

25

Image 25

Uniden 7000A manual Basic Operation, Setting the Dtam to Answer Calls, To Turn The Dtam On, To Announce Only

Contents

7000A Page Contents Contents Read this Before Installation Safety Information Safety Information Safety Information Introduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include Features Features Outgoing Message FunctionsMessage Light Answer Functions Selecting a Location Installation Connecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with this Push down the latch to release the battery compartment cover Page Preparation Setting the DAY and Time Recording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 message Dtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 until Preparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce Only Recording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the Dtam Playing Messages Adjusting the VolumeDown for 2 seconds Pause Message Playback Deleting Messages Fast Playback Recording a Memo Using Call Breakthrough Press Dtam beeps Changing the CBT CodeReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-on Then Remote Operation Press Using Remote Commands Remote Operation Problem Suggestion Troubleshooting Your problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolve Unplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead