Ricoh L4160, L4130 Preparing for the Heaters, Changing the Temperature Settings for the Heaters

Preparing for the Heaters

Changing the Temperature Settings for the Heaters

Set the heater temperature.

Depending on the media and the profile to use, set the heater temperature.

•It may take several minutes to tens of minutes for the set temperature to be reached, depending on the ambient temperature.

• You can change the temperature set here also in [HEATER] of the [SETUP] menu. (P.3-2)

1	Press the	key.		PRE	PRT		POS T
				2 3 ° C 2 3 ° C 2 3 ° C
				Heater temperature
				confirming display
2	Press the	key.		The set temperature: 20 to 70°C
				OF F	OF F		OF F
				( 2 3 ° C 2 3 ° C 2 3 ° C )
3	Press		to set the temperature of	OF F	OF F		OF F
	each heater.			( 2 3 ° C	2 3 ° C		2 3 ° C )
	Heater selecting	: Select with
	Temperature setting : Set with			Current heater		temperature

•The heater starts to get hot.(The [HEAT] lamp lights in orange.)

•When the heater temperature reaches the set temperature, the [HEAT] lamp goes off and the [CONSTANT] lamp lights in green.

4	Press the	key to end the setting.
	• The screen moves to the temperature setting of FAN HEATER.

• The Heater temperature is controllable at the RIP side if the RIP in use has a function controllable. (For the setting procedures, refer to the instruction manual of the RIP in use.)

• Depending on the power supply voltage, amount of heat generation differs. For the power supply voltage of 100V to 120V, it may not reach 70 °C.

•If you set [VACUUM] of the [SETUP] menu more than needs, it may cause temperature decrease of the print heater.

• Use this machine under 20 to 30°C. The temperature may not reach the set value due to the environmental temperature condition.

•When you lower the heater temperature, ensure drying time with the procedures below:

•Set [SET UP] – [DRYING TIME].

•Increase the number of printing passes.

•Print unidirectionally.

2

Basic Operations

2-17