Ricoh L4130 Entering the media remaining amount, Fix the media on the take-up device. P.2-13

16 Fix the media on the take-up device. (P.2-13)

(1) Feed the media up to the core of the roll media of the

take-up device by pressing the key.

• Check the media end is not caught into the slot on the post-heater, and then feed the media.

(2) Fix the middle of the media with adhesive tape.

(3) In the same manner, fix the left side and right side of the media.

• Make sure that the there is no slack or wrinkle on the media in such condition that the roll media is pulled to right and left evenly, and then stick the tape.

(4) Press the key.

• Depending on the media to use, attach/ remove the antistatic sheet. (P.1-19)

• If media floats at the detecting position, it may not be detected correctly.

Entering the media remaining amount

When [MEDIA RESIDUAL] of the maintenance function is "ON" (P.3-12),the screen for entering media remaining amount is displayed after detecting the media width.

1	Display the	screen	for entering media remaining	I NPU T	MED I A	L ENGTH
2	amount.			=		5 0 . 0 m
	Press	and	key to enter the media remaining	I NPU T	MED I A	L ENGTH
	amount.			=		5 0 . 0 m
3	Press the	key.

2-12