Ricoh L4160, L4130 operation manual Errors when performing operations, Message displayed in Local

Warning / Error Messages

If some trouble occurs, the buzzer sounds and the display shows a corresponding error message. Take an appropriate remedy for the displayed error.

Warning messages

Errors when performing operations

Message	Cause	Solution
		Check the front cover and maintenance
I N V A L I D O P E R A T I ON	The front cover or the maintenance	covers.
		If the same error message appears again
CO V E R O P E N	cover is opened.
		even after closing all the covers, contact
		your local distributor to call for service.
I N V A L I D O P E R A T I ON	The media has not been detected.	Perform media detection.
ME D I A U N D E T E C T E D
I N V A L I D O P E R A T I ON	The motor is OFF after the cover	Close the front cover and maintenance
MO T OR P OWE R O F F	was opened etc.	covers.
I N V A L I D O P E R A T I ON		Check the Eco-cartridge for the supply
	An ink error occurred.	path corresponding to the indicated
I N K E R ROR
		color.
I N V A L I D O P E R A T I ON	Data was received.	Perform data clear. (	P.2-29)
D A T A R EMA I N

Message displayed in LOCAL

Message		Cause			Solution
		Ink errors (unusable ink) occur in	Press the				key to check the
< L OC A L >		multiple cartridges.
			Eco-cartridge generating the warning.
C a n’ t P R I N T / C A R T . [ E N T ]		Ink supply (print, cleaning, etc.)
			Replace them with usable cartridges.
		cannot be performed.
< L OC A L >			Check the waste ink bottle.
		The waste ink bottle is nearly full.	Press the		MAINT.		key to correct or
C h e c k w a s t e i n k [ MN T ]
			reset the counter. (				P.4-29)
		Time to replace the wiper in the cap-	Press the		MAINT.		key and replace the
< L OC A L >		ping station with a new one has come.
			wiper with a new one.
R e p l a c e W I P E R [ MN T ]		(The wiping count has reached the
			(	P.4-28)
		specified value.)
		Time to clean the wiper in the capping
< L OC A L >		station with a new one has come.	Press the		MAINT.		key and clean the
W I P E R C L E A N I NG	[ MN T ]	(The wiping count has reached the	wiper. (		P.4-5)
		specified value.)
< L OC A L >		The media is not set.	Set the media. (				P.2-5) If the same
			error message appears again, contact
* * NO ME D I A	* *	The sensor has been broken.
			your local distributor to call for service.
< L OC A L >		The data has been received.	Press the			key to perform print-
			ing.
D A T A R EMA I N
			Or, perform data clear.

5

Troubleshooting

5-11