Ricoh L4130, L4160 operation manual Media jam occurs Remove the media and reset it

Message

Cause

Solution

E R ROR	5 0 5		The media jam occurs.	Remove the media and reset it.
ME D I A	J AM
E R ROR	5 0 c		The media width has not been	Check the media set position. (			P.2-
				8)
ME D I A	W I D T H	S E N SOR	detected correctly.
				Clean the media sensor. (		P.4-4)
E R ROR	5 0 9		A HDC position counter error
HDC POS CN T			occurred.	Turn off the main power to the
				machine and turn it on after a while.
E R ROR	5 0 a
			Y-origin could not be detected.	If the same error message appears
Y OR I G I N
				again, contact your local distributor to
E R ROR	5 0 f		Abnormal linear scale.	call for service.
L - S CA L E B L AC K
E R ROR	5 1 6
ME D I A S E T PO S I T I ON R			The media is set outside the proper	Check the media set position. (			P.2-
			area.	8)
E R ROR	5 1 6
ME D I A S E T PO S I T I ON L
				Turn off the main power to the
E R ROR	6 1 7		The liquid level sensor abnormality	machine and turn it on after a while.
				If the same error message appears
D AMP E R	S e n s : 1 2 3 4 5 6 7 8		of the damper has been detected.
				again, contact your local distributor to
				call for service.
E R ROR	6 1 8		Though a certain amount was con-
			sumed, there is no change in the
D AMP E R / H I GH : 1 2 3 4 5 6 7 8
			damper sensor High.	Perform “DAMPER (	P.5-6) ” of the
				maintenance.
			Though a certain amount was con-
E R ROR	6 1 9			Even if you performed this, when the
			sumed, there is no change in the
D AMP E R / L OW		: 1 2 3 4 5 6 7 8		message is displayed, contact your
			damper sensor Low.
				local distributor to call for service.
E R ROR	6 1 a		Overflow from the damper has been
I N K O v e r f l o w : 1 2 3 4 5 6 7 8			detected.
				Perform “DAMPER (	P.5-6) ” of the
				maintenance. Also check the remain-
E R ROR	6 1 b		Ink could not be supplied to the	ing amount of ink in the Eco-cartridge.
S U P P L Y	I N K	: 1 2 3 4 5 6 7 8	damper.	Even if you performed this, when the
				message is displayed, contact your
				local distributor to call for service.

5-16