Ricoh L4130, L4160 operation manual Been nearly used up

Message

Cause

Solution

< L OC A L >				The ink of the ink cartridge has	Press the	key to check the rel-
					evant Eco-cartridge. Be careful because
I N K N E A R E N D			[ E N T ]	been nearly used up.
					it may be INK NEAR END soon.
					Perform “DAMPER (		P.5-6) ” of the
					maintenance. Also check the remaining
< L OC A L >				Ink could not be supplied to the	amount of ink in the Eco-cartridge.
S U P P L Y	I N K	: MMC C Y Y K K		damper.	Even if you performed this, when the
					message is displayed, contact your local
					distributor to call for service.
					Turn off the power to the machine and
< L OC A L >				The liquid level sensor abnormality	turn it on after a while.
					If the same error message appears
D AMP E R	S e n s : MMC C Y Y K K			of the damper has been detected.
					again, contact your local distributor to
					call for service.
< L OC A L >				Overflow from the damper has been
I n k O v e r f l o w : MMC C Y Y K K				detected.	Perform “DAMPER (		P.5-6) ” of the
< L OC A L >				Though a certain amount was con-	maintenance. Also check the remaining
				sumed, there is no change in the	amount of ink in the cartridge.
D AMP E R / H I GH : MMC C Y Y K K
				damper sensor High.	Even if you performed this, when the
					message is displayed, contact your local
				Though a certain amount was con-
< L OC A L >					distributor to call for service.
				sumed, there is no change in the
D AMP E R / L OW		: MMC C Y Y K K
				damper sensor Low.
S H A K E	WH I T E	I N K		To prevent settling out in the white	Following the procedures, shake the
				ink pack, this is displayed periodi-
C A R T R I DG E S			[ E N T ]		white ink cartridge. (		P.1-14)
				cally.
< L OC A L >			* * * ° C	The machine temperature is high.
M a c h i n e T EMP / H i					Adjust the ambient temperature of the
					installation place.
< L OC A L >			* * * ° C	The machine temperature is low.
M a c h i n e T EMP / L o
< L OC A L >				Time to replace the white ink filter with	Following the procedures, replace the
F I L T E R	R E P L A C E			a new one has come.	white ink filter. (	P.4-34)
				After “error 710 HEATER TEMP	If the ERROR 710 appears again, con-
H E A T E R	T EMP	E R ROR		ERROR” has occurred, the power is
					tact your local distributor to call for ser-
POWE R O F F			[ E N T ]	forcibly turned off, and when you
					vice.
				restart it, this is displayed.

5-12