Ricoh L4130, L4160 Replacing consumables, Replacing the wiper, Wiper, Insert a new wiper

Models: L4160 L4130

1 174
Download 174 pages 34.29 Kb
Page 120
Image 120

Replacing consumables

Replacing the wiper

The wiper is consumable.When the display indicates that it is necessary to

< LOCA L >

check and replace the wiper, immediately replace the wiper with a new one.

REP L ACE WI P ER [ MN T ]

Also, wipe ink sticking to the lower surface of the slider off.

 

• When the warning message for replacing wiper is shown, confirm whether there is no damage and fuzz at the top edge of the wiper film. If there is no damage on the top edge of the wiper film, it is possible to use the wiper continuously without replacing it.

A wiper is a consumable. Buy one through the dealer in your region or at our service office.

When you replace it before the message is displayed, first perform carriage out and then replace it. (P.4-5Steps 1 to 2)

After replacing, reset the counter for the number of times the wiper was used. (P.3-20)

1

Press the MAINT.

key in LOCAL.

REP L ACE

WI P ER

 

 

 

 

 

 

E X ECU T E

 

[ ENT ]

 

 

 

 

 

 

2

Press the

key.

REP L ACE

WI P ER

 

• The carriage moves to the maintenance position.

COMP L E T ED

[ ENT ]

 

 

 

• If the carriage is not covered by the ink cap for a long period of time, the nozzle face of the head may get dry and clogged, resulting in white lines being left in the printed image.

• The buzzer sounds periodically while the carriage is out of the capping station. The buzzer sounds at shorter interval when the print heater temperature is high.

• Until the replacement work is completed, [COMPLETED: ent] is displayed on the screen.

After the work up to the Step 4 is completed and you close the right maintenance cover,

press the key.

3

Open the rght maintenance cover then remove the

Projection

 

wiper.

 

• Pull out the wiper by holding the protrusions at its both ends.

4

Insert a new wiper.

• Insert a new wiper by holding its both ends.

Projection

5

Close the right maintenance cover then press the

 

 

key.

C l o s e a c o v e r

• After its initial operation, the machine returns to LOCAL.

P L E A SE WA I T

4-28

Page 120
Image 120
Ricoh L4130, L4160 Replacing consumables, Replacing the wiper, Open the rght maintenance cover then remove, Wiper