Ricoh L4160, L4130 Tighten the roll holder fixing screw, Insert the roll media in this machine

Setting a Media

4	Tighten the roll holder fixing screw.
	• Check the Step 2 to 3 again.
5	Set the left end of the core of the roll media on the
	left roll holder.
	• Push the roll media onto the roll holder until the roll core is
	all the way seated.
	• Set the media so that the leading end of the media droops
	down and toward the front.
6	Loosen the screw of the right side roll holder then
	insert the holder into the core of the roll media.
	• When the roll holder is not firmly pressed against the core
	of the roll media, the feeding media may be loosened and
	thereby the media reaches to the floor. ( P.5-10)
7	Tighten the screw of the roll holder
8	Raise the clamp lever in the front of this machine.	Clamp lever

9 Insert the roll media in this machine.

Pinch roller

•The roll media can be smoothly inserted by slanting the media.

(1)Pull the media out of the roll to the head of the Media Transfer Surface.

(2)Insert the media between the Media Transfer Surface and the feed roller.

•Pull the media out of the roll so that the media can be grasped from the front of the machine.

(3)Push down the clamp lever from the back of this machine.

•The media is held.

2

Basic Operations

2-9