Changing the Digital Security Code
The digital security code is an identification code used to connect each handset and the base unit. Normally, setting the code is not necessary. The first time you charge each handset in the base, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
1)Remove the handset from the base unit. Press and hold find handset on the base.
2)While holding find handset, place the handset in the base unit, and leave the handset on the base for more than 3 seconds. A new random security code is set.
You can change the phone’s digital security code on either handset. However, you must
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
Headset Installation
Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert the headset plug into the headset jack. Your phone is ready for
(Headset may be purchased by calling the Uniden Parts Department or visiting the web site, see QUICK REFERENCE GUIDE on page 3.)
•To protect you against misbilled calls which might result from your phone being activated by other equipment, the cordless phone provides AutoSecureTM (which electronically locks your phone when the handset is in the base) and Random CodeTM digital security (which automatically selects one of over 262,000 digital security codes for the handset and base).
•If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically the next time the battery pack is charged.
A D D I T I O N A L I N F O R M AT I O N
www.uniden.com | A D D I T I O N A L I N F O R M AT I O N [ 41 ] |
