C. Connect the base unit and charging cradle
Place the handset in the base or charging cradle with the keypad facing forward for charging.
1)Connect each AC adapter to the DC IN 9V jack and to each standard 120V AC wall outlet.
2)Set the base and charging cradle on a desk or tabletop, and place one handset in the base unit and one in the charging cradle.
3)Raise the base antenna to a vertical position.
4)Make sure that the charge/in use and charge LED illuminate. If the LED does not illuminate, check to see that the AC adapter is plugged in and that with the cradle’s charging contacts.
Route the cord.
the handset makes good contact
•Use only the supplied
•Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.
• Connect the AC adapter to a continuous power supply.
• Place the base unit and charging cradle close to the AC outlets so that you can unplug the AC adapters easily.
After installing the battery packs in the handsets, charge your handsets at least
5) Once the handset battery packs are fully charged, connect the telephone line cord to the TEL LINE jack and to a telephone outlet.
If your telephone outlet isn't modular, contact your telephone company
for assistance.
Modular
[ 12 ] G E T T I N G S TA R T E D | www.uniden.com |
