Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing; the default setting is tone dialing. Set the dialing mode to match the dialing system used by your local phone service.
•If you are not sure of your dialing system, make a trial call. If the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
•If your phone system requires pulse dialing and you need to send DTMF tones in certain situations during a call, you may switch over to tone dialing (refer to "Tone Dialing
1)Press menu/clear. Select the Global Setup menu, and |
| ||
&KCN/QFG | |||
| then the Dial Mode submenu. | ||
| 6QPG | ||
2) | Press /vol/∧ or /vol/∨ to select Tone or Pulse | ||
2WNUG | |||
| (the initial setting is Tone). | ||
|
| ||
3) | Press select/ /audio tone. You will hear a confirmation tone. | ||
w w w . u n i d e n . c o m | G E T T I N G S T A R T E D [ 2 4 ] |
GETTING STARTED
