Uniden DX834, DXC834 important safety instructions Dialing a Stored Number, Chain Dialing

Dialing a Stored Number	1. Store the access code into one of the memory
To dial a number previously stored in memory, follow	numbers.
	2. Dial the main number.
these steps:
	3.
1.
Problem	Suggestion
Charge light won’t come on when Handset is placed in Base	∙ Make sure AC Adapter is plugged into the Base Unit and
Unit.	wall outlet.
	∙ Make sure Handset is properly seated in Base Unit.
	∙ Make sure that the charging contacts on the Handset and
	Base Unit are clean.
Audio sounds weak and/or scratchy.	∙ Make sure that the Base Unit antenna is fully extended
	and vertical.
	∙ Move the Handset and/or Base Unit to different locations
	and try again.
	∙ Press the C button to select another channel.
Can’t make or receive calls.	∙ Check both ends of the Base Unit telephone line cord.
	∙ Make sure the AC Adapter is plugged into the Base Unit
	and wall outlet.
	∙ Disconnect the AC Adapter for a few minutes, and then
	reconnect it.
Handset doesn’t ring or receive a page.	∙ Nickel-Cadmium battery pack may be weak. Charge the
	battery on the Base Unit for 15–20 hours.
	∙ Extend the Base Unit antenna vertically.
	∙ The Handset may be too far away from the Base Unit.
	∙ Place the Base Unit away from noise sources.
	∙ The Digital Security Code may be erased. Set the Digital
	Code.

Remove the

Handset from the

Base Unit.

2.Press T.

3.Press M.

4.Press the memory location number (0-9).

Chain Dialing

On certain occasions, after dialing a number, you may be requested by the party or service you are calling to enter a special access code, such as when performing a banking transaction. To do this, simply:

At the appropriate time, press M followed by the memory location number where the access code is saved.

DX834/DXC834 19