Installation
Selecting a Location
Before choosing a location for your new phone, there are some important guidelines you should consider:
∙The location should be close to both a phone jack and continuous power outlet.
Note: A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.
∙Keep the Base Unit and Handset away from sources of electrical noise such as motors or fluorescent lighting.
∙Be sure there is sufficient space to fully extend the Base Unit antenna.
∙The Base Unit can be placed on a desk or tabletop or mounted on a standard AT&T or GTE wall plate.
∙If you decide to mount your phone on the wall, make sure to change the handset retainer so that the tab which holds the Handset faces up. (See page 10 for more information.)
∙You should charge your new phone for
Telephone Line Outlets
There are two types of phone outlets:
Modular Jack
Most phone equipment available now uses modular jacks. Phone cords are fitted with a molded plastic connector which plugs into this type of jack. If you do not have modular phone jacks, contact your local telephone company for information about their installation.
Hard-wired Jack
Some equipment is wired directly to a phone jack, and these types of installations require a modular jack converter. This type of installation is not difficult; however, you should contact your Uniden telephone dealer or a telephone supply store for advice about the proper adapter or converter for your particular situation.
Connecting the Telephone Cords
Consider these safety guidelines before connecting the telephone cords:
Caution!
∙Never install telephone wiring during a lightning storm.
∙Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected.
∙Use caution when installing or modifying telephone lines.
Applying Power to the Base Unit
All the DX834 phone requires an AC outlet, without a switch to interrupt power, and the included AC adapter. To relieve strain on the DC plug when the phone is placed on a desk or table, connect the adapter as shown below.
Wrap the power cord around the convenient notch on the bottom.
Important: Place the power cord so that it does not create a trip hazard, or where it could become chafed and create a fire or other electrical hazards.
6 | DX834/DXC834 |
