EXAI2980A
•Use only the Uniden battery
•Even when the battery pack is not being used, it will gradually discharge over a long period of time.
For optimum performance, be sure to return the handset to the base unit after each telephone call for charging the battery.
•If you must replace the battery pack during a telephone call, complete the replacement within 30 seconds, and you may return to the caller.
B. Install the battery pack
Charge the battery pack for at least
1)Press in on the battery cover release and slide the cover down until it comes of f.
2)Connect the battery pack connector observing correct polarity (black and red wires) to the jack inside the battery compartment.
Do not exert any force on this connection. It could cause damage to the battery or handset. Once you are certain that you have made a good connection, then insert the battery pack into the battery compartment. Do not pinch the wires.
3)Securely close the battery compartment cover by sliding it up until it snaps into place.
4)Place the handset on the base. Remove the beltclip, if attached, for face up charging.
Battery use time (per charge)
From fully charged
•Seven hours continuous use.
•Fourteen days when the handset is in the standby mode.
Low battery alert
When the battery pack is very low and needs to be charged, the phone is programmed to eliminate functions in order to save power. If the phone is not in use, “Low Battery“ appears on the LCD and none of the keys will operate.
If the phone is in use, “Low Battery“ flashes and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base unit for charging.
The last number dialed in the redial memory and the numbers stored in the memory locations are retained for up to 30 minutes while you replace the battery pack.
[ 6 ] G E T T I N G S TA R T E D
