EXAI2980A
If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is
Changing the Digital Security Code
The digital security code is an identif ication code used to connect the handset and the base unit. Normally, set- ting the code is not necessary.
The first time you charge your handset, the security code is automatically set. (See "About the digital security code", page 5.) In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
1)Remove the handset from the base unit. Press and hold page on the base.
2)While the handset is emitting the paging sound, place the handset on the base unit holding page. The paging sound stops.
Leave the handset on the base for more than 5 seconds or until flashing stops. A new random security code is set.
charged.
Installing the Beltclip
Headset Installation
If the beltclip is attached, you can only charge the handset in the face down position.
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the belt- clip to release the tabs from the holes.
Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert headset plug into the headset jack. Your phone is ready for
(Headset may be purchased by calling the Uniden Parts Department or visiting the web site. See Page 4.)
[ 32 ] A D D I T I O N A L I N F O R M AT I O N
