Troubleshooting
If your Cordless Telephone is not performing to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service at (800)
Problem |
| Suggestion |
Charge light won’t come on | • | Make sure AC Adapter is plugged into the Base |
when Handset is placed in |
| Unit and wall outlet. |
Base Unit. | • | Make sure Handset is properly seated in |
|
| Base Unit. |
| • | Make sure that the charging contacts on the |
|
| Handset and Base Unit are clean. |
| • | If the phone is desk/table top installed, make |
|
| sure the Handset is in the vertical position. |
Audio sounds weak and/or | • | Make sure that the Base Unit antenna is vertical. |
scratchy. | • | Move the Handset and/or Base Unit to different |
|
| locations and try again. |
Can’t make or receive calls. | • | Check both ends of the Base Unit telephone line |
|
| cord. |
| • | Make sure the AC Adapter is plugged into the |
|
| Base Unit and wall outlet. |
| • | Disconnect the AC Adapter for a few minutes, |
| • | and then reconnect it. |
| Check TONE/PULSE switch position. | |
Handset doesn’t ring or receive | • | |
a page. |
| Charge the battery on the Base Unit |
|
| for 15 to 20 hours. |
| • | Raise the Base Unit antenna vertically. |
| • | The Handset may be too far away from the |
|
| Base Unit. |
| • | Place the Base Unit away from noise sources. |
Handset does not fully charge. | • | If the phone is desk/table top installed, make |
|
| sure the Handset is in the vertical position and |
|
| the contacts are touching. |
Troubleshooting
EXS9005 | 29 |
