Installing the handset battery pack | Uniden EXS 2050 specs

Installing the handset battery pack

Charge the battery pack for 15-20 hours before you start using your phone.

1 Press in on the battery cover release and slide the cover down until it comes off.

2 Connect the battery pack connector with the correct polarity (black and red wires), then insert the battery pack into the battery compartment.

3

4

Slide the battery cover forward until it snaps into place.

Place the handset on the base.

5 Make sure that the “status” LED lights. If the LED doesn’t light, check to see that the AC adapter is

status LED

plugged in and that the handset makes good contact with the base charging contacts.

Use only Uniden Battery (BT-905) supplied with your phone.

10

Image 13

Uniden EXS 2050 manual Installing the handset battery pack, Use only Uniden Battery BT-905 supplied with your phone

Contents

Page Introduction Features Talk Flash Controls and functions 43 44 45 Contents Base unit Read this firstHandset Checking the package contents Choose the best location Setting up the base unit Connect the base unit If you want to install the base unit on the wall, see If your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing system Standard wall plate mounting Mounting the base unit on a wall Direct wall plate mounting Use only Uniden Battery BT-905 supplied with your phone Installing the handset battery pack When the battery charge becomes low Battery use time per chargeCleaning the charging contacts Do not use any liquids or solvents Other Operations Making a call From the handset Receiving a callFrom the base Ringer mute Handset ringer tone and volume Adjusting the volume Redialing a call Flash and Call WaitingMute Traveling out-of-range Using the page feature Storing phone numbers Chain dialing Making calls with memory dialing Memory dialing Erasing a stored phone number When speaking on the base When speaking on the handsetWay conferencing Integrated answering device Turning the answering system on/off Setting up your answering system Preset Message Setting your greetingRecording a personal outgoing message Greeting Choosing between the two outgoing messages Selecting the message record time Announce only featureSelecting a PIN code Setting ring time switch Playing your messages Using your answering system Skipping a message Repeating a message Voice memo Deleting a messageDeleting individual messages Deleting all messages Recording a conversation Command Function # then Repeat Remote access away from home Remote room monitor Changing the digital security code Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling Maintenance Symptom Suggestion Troubleshooting Symptom Suggestion At Uniden, we’ll take care of you K, L IndexW, X, Y, Z