Registering a handset
Does the handset fit in the base cradle?
Yes | No |
Place the handset in | 1. Disconnect the base AC adapter. |
the base. The display | 2. Press and hold Find while you reconnect the adapter. |
should say Handset | 3. On the handset, press and hold Pound (#) until the |
Registering. | display says Handset Registering (about 2 seconds). |
In about 30 seconds, the display should say Registration Complete. Pick up the handset and press Talk. Make sure you get a dial tone.
If... | Try... |
|
|
- you don't hear a dial tone | Making sure the handset is fully |
- the display says Registration Failed | charged, then trying again. |
To register a handset to a different base, see the section "Expanding Your Phone" in the user's guide for the other base.
Handling Liquid Damage
Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the exterior plastic housing is affected, wipe off the liquid & use as normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can be heard in the phone or liquid has entered the handset battery compartment or vent openings on the base), follow the steps below:
Handset | Base | |
1. Remove the battery cover and leave it off for | 1. Disconnect the AC | |
ventilation. | ||
adapter, cutting off | ||
2. Disconnect the battery pack. Leave the battery | ||
electrical power. | ||
cover off & the battery pack disconnected for at | ||
2. Disconnect the | ||
least 3 days. | ||
telephone cord from | ||
3. Once the handset is completely dry, reconnect | ||
the base. | ||
the battery pack and the battery cover. | ||
3. Let dry for at least 3 | ||
4. Recharge the battery pack for | ||
days. | ||
before using. | ||
|
IMPORTANT: You must unplug the telephone line while recharging the battery pack to avoid charge interruption.
CAUTION! DO NOT use a microwave oven to speed up the drying process. This will cause permanent damage to the handset, base and the microwave oven.
26
