6. Press D.
7. Use)or(to select
the size code for the
first block.
8. Press E.
The next available
block displays.
9. Repeat Steps 7 and 8
until you have
selected a size code
for each block.
For specifics about
each size code, see
Fleet Map Size
Codes in the
Appendix.
10. Press R.
The scanner exits the
Trunking
Programming mode,
acquires the data
channel, and begins
searching using the
map you’ve
programmed.
Programming a Hybrid System
A Hybrid system is simply a Type I system with some
blocks designated as Type II blocks. To program a Hybrid
system, follow the steps listed in Programming a Fleet Map
in the previous section. However, if you want a block to be
Type II, select Size Code S-0.
When you begin searching a trunking bank with a Hybrid
Fleet Map, you will see both types of system IDs. That is,
Type II IDs usually appear as an even number without a
dash; Type I IDs appear as a three or four digit number,
followed by a hyphen, followed by a one or two digit
number. See page 61 for more information.
12345678910
BANK
TRUNK
12345678910
BANK
TRUNK
53