[ 45 ]
THE INTEGRATED
ANSWERING DEVICE
Remote access away from home
You can operate your answering system from a remote location using any
touch-tone telephone. Use this function to check for recorded messages, to
play or delete messages, to record a new outgoing message, and to monitor
sounds in the room.
1Call your telephone number.
2While the greeting message is played, press #and your PIN code within
2 seconds.
If the answering system is off, let it ring 10 times. The tone sounds.
Then, press #and your PIN code within 2 seconds.
3The answering system announces the time and day and the number of
messages stored in memory. Then the message playback automatically begins.
4You may continue to listen to your message, or you may select a command
from the following chart.
5After all of your messages have played, or the playback time exceeds 4
minutes, you will hear intermittent beeps indicating that the system is in
the command waiting mode. You may enter another command at this time
from the chart above.
• During the remote
operation, displays
on the base.
• You must enter a
command within 15
seconds of entering
command waiting
mode. Otherwise the
answering system
automatically hangs up
and returns to standby.
• The system will only
playback messages for
four minutes and then
it returns to command
waiting mode. To
continue playing your
message, press #then
2again within 15
seconds.
Command Function
#then 1Repeat a message
#then 2Playing your messages
#then 3Skipping a message
#then 4Deleting a message
#then 5Stop message playback
#then 6Answering system on
#then 7Voice memo record/stop (up to 4 minutes recording time)
#then 8Greeting message record/stop
#then 9Answer system off
#then *Room monitor
THE INTEGRATED ANSWERING DEVICE
TRU548 ENG O/M 7/18/01 15:43 Page 45