You should only change this option when instructed to by customer service and when you are experiencing one of the following issues:
Issue | Problem | Resolution |
When using an extension phone, | Your phone should detect when an- | Set the Inuse Line Setup to “TYPE- |
“Line in Use” will not appear in the | other extension phone is used. | B” or contact Uniden’s custom- |
original handset display. |
| er service hotline. See back cover |
|
| page for contact information. |
You place a caller on hold. You pick | Your phone system is not detecting | Contact Uniden’s customer serv- |
up an extension handset and finish | that the line was picked up and re- | ice hotline. See back cover page for |
your conversation. You hang up the | leased. | contact information. |
call from your extension handset, |
|
|
but the original station where you |
|
|
placed the caller on hold does not |
|
|
release the line and therefore, thinks |
|
|
you still have a party on hold. |
|
|
Note: Do not set your Inuse Line Setup to OFF unless instructed to by a Uniden Customer Service Representative. If you set the Inuse Line Setup to OFF, your phone cannot detect the status of an extension phone while in use and will not operate correctly.
To change the settings do the following steps:
) Press the MENU soft key on the base. Select the GLOBAL SETUP menu, and then the INUSE LINE SETUP submenu.
2)CHANGE ONLY IF INSTRUCTED BY CUSTOMER SERVICE appears. Press the OK soft key.
3)Move the cursor to select 
or 
. Press the OK soft key.
4)Move the cursor to select
53
