Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing; the default setting is tone dialing. Set the dialing mode to match the dialing system used by your local phone service.
•If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
•If your phone system requires pulse dialing and you need to send DTMF tones in certain situations during a call, you may switch over to tone dialing (refer to “Tone Dialing
1) | Enter the Global Setup menu, and then the Dial Mode | &KCN/QFG |
| |||
| submenu (see "Entering the Menu" on page 16). |
| ||||
| 6QPG |
| ||||
2) | Press | volume up/down to select Tone or Pulse (the | 2WNUG |
|
|
|
| initial setting is Tone). | $#%- | &'.'6' |
| 1- | |
|
|
|
|
| ||
3) | Press the OK soft key. You will hear a confirmation tone. |
| ||||
w w w . u n i d e n . c o m | G E T T I N G S T A R T E D [ 3 1 ] |
G E T T I N G S T A R T E D
