Read This Before Installation
We have designed your telephone to conform to Australia or New Zealand Radio Frequency regulations, and you can connect it to most telephone lines. However, each device that you connect draws power from the phone line. We refer to the power drawn as the devices ringer equivalence number or REN. The REN is shown on the bottom of your telephone (New Zealand Models only). If you are using more than one phone or other device on the line, add up all the REN's.If the total is more than five, your phones might not ring. In rural areas, a total REN of three might impair ringing operation.
Note: You must not connect your phone to any of the following;
*Coin operated systems
*
*Most electronic key phone systems
Your phone operates on standard radio frequencies. It is possible for other radio units operating nearby on similar frequencies to unintentionally intercept your conversation or cause interference. Possible lack of privacy can occur with any cordless telephone.
IMPORTANT NOTICE
You must charge the new battery for at least 12 hours before you use the phone.
Installing Your XC 320
Connecting the Telephone line
Plug the telephone line cord from the Base Unit into a standard telephone socket.
(Note: Ifyou do not have a telephone socket contact Telecom for further information.)
CAUTION:
.
.
.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
. Use caution when installing or modifying telephone lines.
11
