NTI UNIMUX
An arrow to the left of a port number in the list indicates |
| ||
the port the user is currently connected to. From |
| ||
left to right, the columns display the following: | Cursor | ||
• | Port Number | ||
| |||
• | Port Name | Port Number | |
• | Power Status of the CPU (ON/OFF) | Port Name | |
|
| ||
Note: “NAC” indicates a
•The actual user number
•If no user is connected to a CPU, the user number is replaced by a
•If more than one user is connected to the same port, this field will indicate the total number of users connected and the text color will be red.
User
Power
Status
Scroll Bar
Menu
Items
Figure 9- Command Mode main menu-User
Note: While in Command Mode, the numbers on the NUM PAD on the keyboard are not active. If numbers are required while in Command Mode, use the numbers on the main key bank.
The list below describes the command functions available from the keyboard within the OSD mode of control after entering into Command Mode:
Function | Keystroke |
|
|
Select the previous port | up arrow |
|
|
Select the next port | down arrow |
|
|
Go to specific port- Press any valid number from 1- | port # - Enter |
1024 to connect to a desired port. |
|
|
|
Increases the ports listed by 1 page | Page Down |
|
|
Decreases the ports listed by 1 page | Page Up |
|
|
Enter “Change Settings” menu | T |
|
|
Toggle ports listed to view by port number or | O (letter, not |
alphabetically by port name | number) |
|
|
Enable/disable Scan Mode | S |
|
|
Enable/disable Broadcast Mode | B |
|
|
Enable/disable Sharing | H |
(only available if the Administrator is logged in or if |
|
security is disabled) |
|
|
|
Enter Administrator menu | A |
(only available if the Administrator is logged in) |
|
|
|
Select the first port on the switch | Home |
|
|
Select the last port on the switch | End |
|
|
Display Help menu | F1 |
|
|
Global Help- display window navigation tips used | F2 |
throughout all menus |
|
|
|
Display port information- when pressed, a window | F3 |
displays the port name and its position in the |
|
configuration structure by level and port number |
|
|
|
Update configuration- use to update the information | F5 |
describing the structure of the cascaded switches. |
|
Use if a slave is |
|
initial startup |
|
|
|
Note: The user must exit Command Mode to type to a CPU.
To exit Command Mode press <Esc> on the keyboard.
13
