CHECK THERMOSTAT OPERATION
temperature display.
This is an excellent feature if the thermostat is in a poor location for sensing temperature or the thermo- stat is in a separate room to prevent tampering.
NOTE
The remote sense feature will not work if the system does not provide 24V to the thermostat (example: millivolt
To use a remote sensor, jumper W922 must be clipped (see figure 9) and the REMT SEN option in the configuration menu must be set to ON.
After the thermostat is installed and configured, do the following to ensure proper operation.
FAN OPERATION
If your system does not have a G terminal connection, skip to “Heating System” section.
1. Turn power on to the system.
2. | Press | FAN | until FAN ON is |
| displayed. The fan should begin | ||
| to operate. |
| |
3. | Press | FAN | until FAN AUTO |
| is displayed. The fan should stop | ||
| operating. |
|
HEATING SYSTEM
1.Press SYSTEM until HEAT is displayed. If the heating system has a standing pilot, ensure that it is lit.
2.Press to adjust thermostat setting above room temperature. The heating system should begin to operate.
3.Press to adjust temperature below room temperature. The heating system should stop operating.
21
Installation