Insert the wires into the terminals on the base using the appropriate wiring diagram and tighten the terminal screws.
CONFIGURING
AND PROGRAMMING
Before the power is turned on, the thermostat must be configured to operate properly with the system. See the CONFIGURATION section of this manual.
This thermostat can be programmed for automatic temperature control. Refer to Operating Instructions for 1
programming.
2
3
4
| 4 |
2 | 3 |
1 |
|
S1 S2 S3 | 1 |
| |
MV W RH RC G | Y O B 6 |
Mounting screws Figure 1. Thermostat base and terminals
Pull wires through this opening
Insert wires into terminal holes, then tighten screws
Screw anchors
7
Installation