Univex A9DN1UH, LD190SS1 owner manual Stereo Sound Mode, Virtual Surround

Stereo Sound Mode

CD

This unit allows you to select a sound mode during CD playback.

During playback, press [AUDIO] repeatedly until the desired sound mode appears.

STEREO

•Each time you press [AUDIO], the sound mode changes as example below.

STEREO (stereo sound with left and right channels)

L-ch(left channel sound only)

R-ch(right channel sound only)

Note:

•Virtual surround cannot be changed when the sound mode is set to either “L-ch” or “R-ch”.

Virtual Surround

You can enjoy virtual surround on your 2 channel stereo system.

1 During playback, press [MODE] repeatedly until “			”
	appears.
		OFF (SURROUND)
2 Press [Cursor K/ L] to select the sound level.
	or
		1 (SURROUND)

1 : Natural effect.

2 : Emphasized effect.

OFF : No effects (original sound).

3 Press [BACK] to exit.

Note:

•The setting will be kept even if the unit is turned off.

•For audio CD, virtual surround will not be effective if the sound mode is set to something other than “STEREO”. Refer to “Stereo Sound Mode” on page 43.

•Turn down the level or select “OFF” if the sound is distorted.

	Español			Français														English
		Marker Setup																		INTRODUCTION
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1 During playback, press [MODE] repeatedly until																				PREPARATION
	“ ” / “ ” appears.		e.g.) DVD
					_ _ /12						(SEARCH)
2 Use [Cursor K/ L] repeatedly until marker search
																				WATCHING
	menu appears.
	or				1		2	3	4	5	6	7		8	9	10	AC
																				TV
3 Use [Cursor s / B] to select an available marker within
																				OPTIONAL
	60 seconds.
						1	2					4 5 6			9	10	AC
																				SETTING
4 When the playback reaches the point at which you
	want to set a marker, press [ENTER].
	• Marker is now set.																			OPERATING
							2	3	4	5	6		7	8	9	10	AC
																				DVD
5 Press [BACK] to exit.
To return to the marker later																				DVD
																				SETTING
1 Repeat steps 1-2 in “To set a marker”. Use [Cursor s																			/ B]
	to select the desired marker.
			e.g.) DVD
																				TROUBLESHOOTING
							2	3	4	5	6		7	8	9	10	AC
2 Press [ENTER] at the desired marker to restart playback
	from the specific point which you set.
							2	3	4	5	6	7	8	9	10	AC
																				INFORMATION
	Note:
	• Marker search menu will disappear in about 60 seconds
	when there is no input.
	• You can mark up to 10 points.
	• To clear a marker, select the marker to be cleared, and then
	press [CLEAR].
	• Ejecting the disc or turning off the power will erase all
	markers.
	• Selecting “	” at step 3 in the section “To set a marker” will
	also erase all markers.

43

EN