2.Place the battery onto the phone, bottom first so the tabs go into the bottom of the phone and the metal connectors align. Then push the battery down until it locks into place.

3.Place the battery cover over the battery and slide into place.

Note: If the battery is not correctly placed in the compartment, the phone will not turn on and/or the battery may detach during use.

Removing the Battery

To remove your battery:

Pull down the release latch, lift up the battery cover and remove the battery from the phone.

Charging the Battery

Your Sprint PCS Phone’s LiIon battery is rechargeable and should be charged as soon as possible so you can begin using your phone.

Keeping track of your battery’s charge is important. If your battery level becomes too low, your phone automatically turns off and you will lose all the information you were just working on. For a quick check of your phone’s battery level, glance at the battery charge indicator located in the upper- right corner of your phone’s display screen. If the battery

charge is getting too low, the battery icon blinks and the phone sounds a warning tone.

Always use a Sprint-approved desktop charger, travel charger, or vehicle power adapter to charge your battery.

Warning: Using the wrong battery charger could cause damage to your phone and void the warranty.

Using the Charger

To use the travel charger provided with your phone:

Connect one end of the charger into the phone's charger jack and plug the other end into a standard 100~240V AC wall outlet. You can monitor the battery status by checking the battery level indicator.

It takes approximately 3 hours to fully recharge a completely rundown battery. With the Sprint-approved LiIon battery, you can recharge the battery before it becomes completely run down.

Phone Basics

24

Section 2A:Your Sprint PCS Phone – The Basics

Section 2A:Your Sprint PCS Phone – The Basics

25

Page 20
Image 20
UTStarcom CDM-105 warranty Removing the Battery, Charging the Battery, Using the Charger