Vanguard Heating FB32NCA, FB32CA, NLFB32C Continued, Installing Fireplace Screen, Hearth, Base

INSTALLATION

Continued

INSTALLING FIREPLACE SCREEN

1.Insert each rod through nine rings located at top of screen.

2.Insert first rod into rear hole in left side of firebox. Fasten rod to rear hole near center of firebox using black shoulder screw.

3.Insert other rod into front hole on right side of firebox and fasten using remaining shoulder screw.

Front and

Rear Hole

Screw

Rod

Ring

Screen

Figure 16 - Installing Fireplace Screen

(Shown Without Fireplace Hood for

Clarity)

FIREBOX INSTALLATION USING OPTIONAL ACCESSORY MANTELS

This firebox may be installed using the corner or cabinet mantel with hearth base accessories against a wall in your home. You must use a GA6090 brass trim kit included with the mantel accessories (see Accessories, page 12). Follow the instructions below to install the firebox in this manner.

Note: The instructions below show installation using GM100F/GM101U/GM102W/GM106F/ GM107U series cabinet mantels and the G3000F/ G3001U/G3004W/G3006F/G3007U series hearth base accessories. The hearth base accessory shown is optional for this installation. You can install firebox and cabinet mantel directly on the floor. The corner mantel cannot be installed with the G3000F/G3001U/G3004W/G3006F/G3007U series hearth base. You must install corner and face mantels directly on the floor. If mounting firebox and cabinet mantel to the floor or using corner mantel, an optional G3005 Slim Base kit may be installed.

1.Assemble cabinet mantel, hearth base, brass trim, and trim accessories. Assembly instruc-

tions are included with each accessory.

2.If using an optional GA3700 blower (FB32CA and NLFB32C models only), install a properly grounded, 120 volt three-prong electrical out- let at firebox location if an outlet is not there. If possible, locate outlet so cabinet mantel will cover it when installed (see Figure 18).

3.Install gas piping to firebox location. This instal- lation includes an approved flexible gas line (if allowed by local codes) and a manual shutoff valve. The flexible gas line must be the last item installed on the gas piping. See Connecting to Gas Supply in your log set ownerʼs manual.

NOTICE:Aqualified service per- son must connect firebox to gas supply. Follow all local codes.

4.Place hearth base accessory against wall at instal- lation location. Cut an access hole in hearth top to run flexible gas line to firebox (see Figure 17). Make sure to locate access hole so cabinet mantel will cover it when installed. Note: You can secure base to floor using wood screws. Countersink screw heads and putty over.

5.Route flexible gas line through access hole in hearth base.

6.Center cabinet mantel on hearth base (see Figure 18). Make sure mantel is flush against wall.

Hearth	Rigid	Pipe and	Electrical	Gas Line
	Gas Shutoff		Outlet	Access
Base
	Valve			Hole

Figure 17 - Placing Hearth Base

Accessory Against Wall

Cabinet Mantel

Figure 18 - Installing Cabinet Mantel

105604-01H www.desatech.com 13