INSTALLATION
Continued
7.Break off nailing flanges (see Figure 19) with hammer or pliers.
IMPORTANT: When installing Brass Trim Kit, see instructions included with mantel accessory.
8.Place cardboard or other protective material on top of hearth base. Carefully set firebox on protective material, with back of firebox inside mantel opening.
9.Attach flexible gas line to log set. See Con- necting to Gas Supply in your log set ownerʼs manual.
10.If installing GA3700 blower (FB32CA and NLFB32C models only), route blower electri- cal cord through bushing included with blower accessory in right side firebox support and bushing in side access opening of firebox. Plug electrical cord into electrical outlet. See Installing Blower Accessory, page 10.
11.Carefully insert firebox into cabinet mantel. Be careful not to scratch or damage hearth base, cabinet mantel, or any laminate trim on hearth base. Remove protective material from top of hearth base and from front of firebox (if any). See Figure 20.
12.Install the trim after final finishing and/or painting of wall. See instructions included with mantel accessory for attaching brass trim.
13.Check all gas connections for leaks. See Checking Gas Connections in log set ownerʼs manual.
Nailing
Flanges
Figure 19 - Location of Nailing Flanges
Figure 20 - Inserting Firebox Into
Cabinet Mantel
BUILT-IN FIREBOX INSTALLATION
1.Frame in rough opening. Use dimensions shown in Figure 21 for the rough opening. If installing in a corner, use dimensions shown in Figure 22 for the rough opening. The height is 33" (FB32CA and NLFB32C) or 34 1/4"(FB32NCA and NLFB32NC), which is the same as the wall opening in Figure 21.
|
|
|
| 17 | 3 | /4" | |
33" (FB32CA and |
| ||||||
|
| NLFB32CA) |
|
| |||
34 | 1 | /4" | (FB32NCA and | ||||
| |||||||
|
|
| NLFB32NCA) | ||||
|
|
| 34 | 3 | /4" |
| |
Figure 21 - Rough Opening for Installing | |||||||
|
|
| in Wall |
|
| ||
393/8"
| 27 7/8" |
34 | 3/4" |
55 | 5/8" |
Figure 22 - Rough Opening for Installing | |
in Corner | |
14 | www.desatech.com |
