Vanguard Heating VMH10TN Assembly, Assembling Fireplace, Installing Log, Assembling Hood

ASSEMBLY

WARNING

WARNING ICON G 001

Always have branch support and screen in place before operating fireplace. This prevents excessive temperatures on fireplace surfaces.

ASSEMBLING FIREPLACE

Tools Required: Phillips screwdriver, 5/16" hex wrench, and slotted screwdriver

Installing Log

1.Remove back log, branch, and hood from log box. Discard protective packaging.

2.Remove two shipping screws above screen (see Figure 2).

3.Lift screen up and pull out to remove.

4.An optional blower is available. See Accessories, page 29. Install optional blower now. Follow installation instructions provided with blower.

5.Gently place back log on burner support (see Figure 2). The log should fit flat against top of burner support. Place two #10 one-inch-long screws through burner support into the log and tighten. Place branch on branch support (see Figure 2).

6.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.

Back Log		Screen Shipping Screw
		Shoulder Screw
		Burner
	Screw	Support

Screw Branch

Support

Screen Branch

Figure 2 - Assembling Fireplace

WARNING

WARNING ICON G 001

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury

Assembling Hood

1.Locate four black phillips sheet metal screws from the hardware packet.

2.Place hood over top edge of firebox wrapper.

3.Attach screws (see Figure 3).

Figure 3 - Assembling Hood

103670

5