INSTALLATION
Continued
Methods For Attaching Mounting Bracket To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 14 inches apart from their centers. Attach mounting bracket to wall in one of two ways:
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to Wall Stud: This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to Wall Anchor: This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Ei- ther method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.
WARNING: Maintain mini- mum clearances shown in Fig- ure 8. If you can, provide greater clearances from floor and join- ing wall.
2.Mark screw locations on wall (see Figure 8). Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3.Remove tape and mounting bracket from wall.
16" | 14" |
Min. |
|
WallAdjoining | Only Insert Mounting | 25 3/4" | |
Optional | |||
| Screws Through Last | 19 3/4" | |
| Hole On Each End | ||
|
|
| Min. |
| Floor |
|
|
4 and 5 Plaque Heaters |
| ||
12" | 14" |
|
|
Min. |
|
| |
AdjoiningWall | Only Insert Mounting | 25 3/4" | |
Optional | |||
Screws Through Last | 19 3/4" | ||
| Hole On Each End | ||
|
|
| Min. |
Floor
3 Plaque Heater
Figure 8 - Mounting Bracket Clearances
Attaching Mounting Bracket To Wall Note: Wall anchors, mounting screws, and spac- ers are in hardware package. The hardware pack- age is provided with heater.
Attaching To Wall Stud Method
For attaching mounting bracket to wall studs
1.Drill holes at marked locations using 9/64" drill bit.
2.Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.
3.Insert mounting screws through bracket and into wall studs.
4.Tighten screws until mounting bracket is firmly fastened to wall studs.
Attaching To Wall Anchor Method
For attaching mounting bracket to hollow walls (wall areas between studs) or solid walls (concrete or masonry)
1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry),
drill at least 1" deep.
www.desatech.com | 9 |
